1 条，规格： 2.5 米） l Power cord (quantity: 1 , specification: 2.5 meters)
1个） l Machine U-shaped buckle fixing cover (number: 1)
1个） l Back cover of power cable interface (number: 1)
1 个） l bracket back pad (quantity: 1 )
4 个） l screws (number: 4 )
l GPS antenna (number: one, customized)
1 个，订配） l side cover of the machine (quantity: 1 )
GPS 天线，如需要采购请与我司业务员联系。 1. GPS antenna is used for special purpose, GPS antenna is not required for standard installation . If you need to purchase, please contact our salesman.
1 ：确认安装的位置。 Step 1 : Confirm the installation location.
2 ：电源线接好扭紧。 Step 2 : Tighten the power cord.
U 型扣将收费机固定在相应的铁柱或扶手上，如下图所示。 Step 3 : Use the U -shaped buckle to fix the toll collection machine on the corresponding iron pillar or handrail, as shown in the figure below.
Dedicated power supply: The brown wire connects the positive pole of the battery on the car, and the blue wire connects the negative pole of the battery on the car.
Note: brown positive, blue negative.
Remarks: If the power supply connector is reserved for the handrail of the fixed consumer machine, you only need to connect our matching power cord to use it (refer to Figure 1). If there is no power connector reserved, please find a set of 24V power cables from the vehicle console (usually the bus box on the right side of the front door of the bus).
Power requirements: normally-on power that is not controlled by the key but controlled by the main gate (refer to Figure 2)
｛Refer to Figure 1｝ ｛Refer to Figure 2｝